Free Shipping on All Orders
The Armor Blush Repair is a solvent based acrylic coating repair designed to repair white spots, blushing, hazing, and bubbles that may appear on acrylic coatings.
$64.99 – $224.99
The Armor Blush Repair is a solvent based acrylic coating repair designed to repair white spots, blushing, hazing, and bubbles that may appear on acrylic coatings.
$64.99 – $224.99
Up To 200 ft2/gallon
Not Applicable
Not Applicable
Solvent Based
The Armor Blush Repair is a great solution for repairing solvent based acrylic sealers that have developed a white haze or bubbles. It is easy to use, works fast, and will instantly refresh and renew solvent based acrylic sealers.
The Armor Blush Repair can be used to repair white spots, hazing, bubbles, and delamination caused by:
The Armor Blush Repair can be applied with a 3/8-1/2” nap roller.
Time Of Day
The Armor Blush Repair will re-emulsify solvent based acrylics and allow them to properly re-cure. Because of this, the same precautions taken when applying a solvent based acrylic sealer should be take when applying the Armor Blush Repair. The Armor Blush Repair should only be applied in the early evening when air and surface temperatures are declining, and when the sun is no longer positioned over the surface. To avoid bubbling and hazing, do not apply in the morning or middle of the day.
Surface Preparation
The Armor Blush Repair should be applied to a completely clean and dry surface. If the surface was cleaned with water or pressure washed prior to application, allow the surface to dry for at least 24 hours before sealing.
To use, simply saturate the roller with Armor Blush Repair. Roll over the problematic area for about 30-60 seconds (or until the acrylic gets sticky). Roll it out smoothly and let cure. Do not apply to large areas all at once. Instead, work in small sections.
The Armor Blush Repair is designed specifically for use on solvent based acrylic sealers. The Armor Blush Repair should not be used on water based acrylics, or on any other type of sealer or coating. If your solvent based acrylic sealer is experiencing hazing, blushing, or delamination caused by applying it over an incompatible sealer or coating, you will need to use the Armor CR100 Coating Remover instead.
Please note, the Armor Blush Repair is not a solvent based acrylic sealer substitute. If your solvent based acrylic sealer is old and degraded, or missing sealer in some areas of the coating, the Armor Blush Repair will not fill in or recoat those areas. To fill in or re-coat those areas, you will need to recoat with a solvent based acrylic sealer.
Clean-Up
Use Xylene or acetone. Dispose of containers in accordance with local and federal regulations.
Product Removal
The Armor Blush Repair can’t be removed, as it does not leave behind a film or coating.
Up to 200 ft/gallon.
Coverage will vary depending on porosity, surface condition, application method, and the amount of material applied by the applicator. The above coverage rates are estimates and will vary.
The Armor Blush Repair can be used to repair interior and exterior solvent based acrylic sealers.
Not applicable.
Not applicable.
T (866) 306-0246
Foundation Armor
3 Howe Drive, Suite 2, Amherst, NH 03031
CAGE Code: 77PK6
DUNS: 078654562
Primary NAICS: 325510
Women Owned Business Certified (WBENC)
DOT DBE Certified