The Armor Rust Remover can be applied with a 3/8-1/2” nap roller, or a commercial-grade acid resistant pump sprayer.

Application

For tough stains, apply the Armor Rust Remover undiluted, right out of the bottle. For lighter stains, dilute the Armor Rust Remover with up to 3 parts water. If diluting with water, use cold water.

To start, saturate the surface to be cleaned with clean water. Using a commercial-grade acid resistant pump sprayer, apply the Armor Rust Remover at a rate of 100-200 ft2/gallon depending on the porosity of the surface. When applying to vertical surfaces, apply from the bottom to the top. Work in small areas, do not exceed 200 ft2 to ensure the area is well saturated. Allow the Armor Rust Remover to remain on the surface for approximately 5 minutes. After 5 minutes, use a stiff bristle brush to work in and agitate any heavily soiled areas to help break the bond to the substrate. Using a pressure washer, or a garden hose with a high pressure spray head, flush the cleaned surface with water. If necessary, repeat the process. For heavy stains, spot clean using the Armor Rust Remover undiluted.

Please note, it is always suggested to test the product in a small, inconspicuous area on the same substrate to test for desired results prior to application.

Clean-Up

Use soap and warm water. Dispose of containers in accordance with local and federal regulations.

Up to 200 FT2/gallon.

Coverage will vary depending on rust and iron build-up, porosity, surface condition, dilution ratio, application method, and the amount of material applied by the applicator. The above coverage rates are estimates and will vary.

Designed for removing rust and iron stains from concrete, pavers, and other cement-based materials.

It is always suggested to test the product in a small, inconspicuous area on the same substrate to test for suitability and compatability prior to application.

N/A

N/A