1 GAL Armor Concrete Cleaner and Micro Etcher

Details

The Armor Concrete Cleaner & Micro Etcher deep cleans the concrete and opens up surface pores to allow for adequate adhesion for concrete coatings, and better acid staining color development and reaction.

Uses

Always test the concrete to be prepared for previous coatings. This product will not work properly over coated concrete surfaces and is not to be used as a chemical coating stripper.

• Protect all areas not to be cleaned and prepared.
• Dilute material with water to desired dilution rate.
• Using a polyethylene pump sprayer, apply at a rate of up to 150-300 sq. ft. per gallon. An acid brush may be used to brush in material for a better application. Always use an acid resistant plastic sprayer and acid resistant brush.
• Allow 5-10 minutes for proper reaction then rinse thoroughly with a mop and PH balancing solution (such as water and ammonia, or water and baking soda). Remove standing water with a wet vacuum. Repeat until floor is clean and free of all material.
• Allow the area to dry 18-24 hours.

Coverage

Coverage rates vary depending upon surface porosity and texture, and application method. Excessive build up should be avoided. Each gallon will cover up to 250 square feet per mixed gallon. If diluted with 3 gallons of water, will cover up to 1,000 square feet per gallon of concentrate.

Benefits

• Concentrated - makes up to 4 gallons.
• Deep penetrating - will remove stains deep within the concrete.
• Will remove mud stains, rust, and corrosion deposits.
• Works to quickly lift stains.