Armor Nano Guard
- Buy 5 for $71.20 each and save 5%
Armor Nano Guard is an L3000 lithium silicate infused nano resin acrylic. Designed to give standard concrete surfaces a beautiful sheen while providing improved resistance to stains and an increased surface hardness. Concrete surfaces treated with the Armor Nano Guard will substantially increase resistance to surface abrasion, water damage, and attacks from chemicals.
BENEFITS:
- Contains high amounts of Lithium to increase surface strength and combat surface ASR.
- Low odor and easy to use formulation.
- Penetrates and bonds to polished and smooth troweled concrete
- UV stable and breathable materials that will not peel, flake, discolor, or yellow.
- Provides superior sheen, and resistance to abrasion and scuffing.
- Able to be burnished to a high gloss shine.
COVERAGE:
One gallon of Armor Nano Guard will cover up to 500 FT2 in one coat.
APPLICATION:
SURFACE PREPARATION: Always test surface to be treated prior to application. Concrete surface must be clean and free of all con-taminants and water. If moisture is present or if the surface is not clean and free of all contaminants, the sealer may have white spots and have premature de-lamination and failure.
MIXING: Do not dilute when applying to conventional steel troweled concrete and cement terrazzo flooring. Dilute only up to 1:1 with fresh water when applying to polished and semi-polished surfaces.
APPLICATION: Lightly wet a clean microfiber mop pad with Armor Nano Guard. Wring out excess to ensure pad is only damp. Using an industrial quality pump-up sprayer fitted with a 0.5 gpm spray tip, apply a light spray over an area only from one control joint to another. Do not atomize. Maintaining a wet edge using the damp microfiber mop pad, immediately spread the Armor Nano Guard as far as possible to produce an even, thin coating. Armor Nano Guard dries quickly when applied per application specifications. Stop spreading as drying occurs and avoid overlapping. Allow to dry up to 60 minutes, or until tack free. Re-apply to desired gloss/appearance as necessary, following the same directions noted above, for up to two additional coats. Note, when applied correctly, no excess material should remain on the surface and the surface will look damp without free liquids.
BURNISHING (not required): Once dry final application is completely dry, using a high quality burnishing pad specified for high gloss finishes, burnish Armor Nano Guard. Burnishing not only provides a smooth high gloss, polished look, but also allows the treatment to bond and fuse with the concrete surface. This provides great product longevity and excellent durability. It is highly recommended to ensure that the temperature behind the burnisher reaches a minimum of 90 F or better. It is not recommended to burnish in between coats.